Originally Posted by philthy phil

So, I worked on my cctl and got that all worked out, but I was still getting this oddball vibration. SO SInce I just changed out the rear swingger and all of that gear I thought It would be a good time to go back and check to see if everything was still torqued to spec. Everything checked out. So I worked the slack out of the throttle and the clutch (things that I haven't done since I bought the bike new). I checked some of the other hardware. When I pulled the right fairing of I noticed that the frame-slider was loose and I looked in through the frame and it appeared that the bolt went through the slider/frame and then straight into a rubber motor mount, so I tightened it back up to where it needed to be and viola! No more annoying rattle. So am I right about that bolt running into a motor mount or am I seeing things, because it sure seems to have done the trick...